Product Information - Table / Generator / Fixtures / Technical Specifications

Table
The base and top plate of the Vacu-Vise™ are constructed of high-grade anodized aluminum with stainless steel fastener hardware. Delrin strips are used for part squaring. For part-holding, foam gasket material fits into the grid matrix channels to create a vacuum seal around the part periphery. Side clamps and Mitee Bites clamps provide an additional holding option.

Part Number #V V1212

  • Keyed for quick set up

  • Holds aluminum, plastic, ferrous and other non-ferrous materials

  • Easily configured to hold thin, flat, or irregular shaped parts

  • Excellent for machining under flood coolant conditions

  • Replaceable top matrix plates available

Top of Page


Part Number #VG01		 Venturi Vacuum Generator

  • Operates off shop air

  • No moving parts to deteriorate

  • Easy mounting 

  • 2 liter container for coolant overflow capture

  • Slide valve for quick clamping and release

  • Vacuum gauge included

Top of Page

Vacu-Vise™ Fixtures

#V V1212

The 12" x 12"  table comes with the following hardware:

            2 - 11" low profile plastic guide bars

            3 - slide clamps

            3 - Mitee-bite™ clamps

            2 - Sine-keys to fit a .625" slotted machine table

            1 - *" tubing fitting

            1 - 50' roll of *" closed celled gasket cord 

#V V2416

The 24" x 16"  table comes with the following hardware:

            4 - 11" low profile plastic guide bars.

            6 - slide clamps

            6 - Mitee-bite™ clamps

            2 - Sine-keys to fit a .625" slotted machine table      

            1 - *" tubing fitting

            1 - 50' roll of *" closed celled gasket cord 

 


Top of Page  

Technical Specifications

Typical Vacu-Vise™ Fixturing Examples

 

 

  • All cuts are made at 60% cutter width at 5000 rpm with a holding vacuum of 27" HG(-13psi)

  • Requires at least 85 psi of shop air

  • Uses 1.2 to 1.8 cfm

CNC Machine Control Home

CNC Control Solutions
22910 Kenwyk Dr
Southfield, MI 48034
Ph:  248 376-1250
info@cnccontrolsolutions.com