Centroid DP-4
Centroid's DP-4 all-surface touch probe can probe any rigid surface. The DP-4 comes with a
ruby-tipped carbide stylus and a protective case. This patented, made-in-USA probe is
highly accurate and outperforms other more-expensive probes on the market.Reduced
Setup Times
Probing will determine dimensions from a sample part for use in machining a duplicate, all
on the same mill.
End Manual Part Setup
End the constant struggle to setup each part. Let the probe seek out your coordinate
offsets for you. Simply place the part into the fixture. Move the probe near the desired
location. Enter Part Setup and press AUTO. Follow the directions on screen and the probe
will find the part location.
Automatically Find Centers/Corners
Locate the centers and corners of Bores, Bosses, Slots, and Webs. Six Probing cycles allow
you to find these positions at the touch of a button. Place the probe into the machine.
Enter the Probing cycles screen. Select the appropriate cycle. Follow the directions
on-screen. It's simple. No special codes. No hassle. |
